The largest collection of swords, weapons and more from the Bronze Age to World War II

Medieval Dragon Buckle – Lord of Battles

$9.50

In stock

This medieval Dragon buckle is made of brass. It fits an approximately 3/4” inch (19 mm) wide belt.

Directions for Use and Tips: Brass fittings with pegs are intended to be riveted onto leather. For this we recommend using a brass washer and a ball peen hammer. When the leather and washer are in place the peg is lightly hammered until it mushrooms over the rivet to secure it into place.

Brass is softer than steel and care must be taken not to strike the pegs too hard – striking them with too great a force risks bending or breaking them. The rounded part of a ball peen hammer is useful for shaping the flattened mushroom head to get an optimal fit. Please Note that the brass pin must not extend too far past the leather and washer before hammering as only a small portion of the pin is needed to flatten and fit it to the leather. If the pins are too long you will risk bending or breaking them without getting a tight fit. If they are too long they can be cut down to a proper size before hammering.

Brass washers that can be used for this purpose are available separately in a thumbnail link on this page.

Reviews

There are no reviews yet.

Be the first to review “Medieval Dragon Buckle – Lord of Battles”

Your email address will not be published. Required fields are marked *

0
    0
    Your Cart
    Your cart is emptyReturn to Shop