The largest collection of swords, weapons and more from the Bronze Age to World War II
LOB Black Background

Lord of Battles – Medieval Brass Belt Chape

$5.99

In stock

Additional information

This Medieval Belt Chape of cast brass will fit a belt end tapered to approximately .56 / 14.28 mm

Directions for Use and Tips: Brass fittings with pegs are intended to be riveted onto leather. For this we recommend using a brass washer and a ball peen hammer. When the leather and washer are in place the peg is lightly hammered until it mushrooms over the rivet to secure it into place.

Brass is softer than steel and care must be taken not to strike the pegs too hard – striking them with too great a force risks bending or breaking them. The rounded part of a ball peen hammer is useful for shaping the flattened mushroom head to get an optimal fit. Please Note that the brass pin must not extend too far past the leather and washer before hammering as only a small portion of the pin is needed to flatten and fit it to the leather. If the pins are too long you will risk bending or breaking them without getting a tight fit. If they are too long they can be cut down to a proper size before hammering.

Brass washers that can be used for this purpose are available separately in a thumbnail link on this page.
2 1/8” x 3/4”
For belts ends tapered to approximately 9/16” wide (14.28 mm)

MaterialBrass
ManufacturerLord Of Battles
Country of OriginIndia

Lord of Battles Belt Ends

Reviews

There are no reviews yet.

Be the first to review “Lord of Battles – Medieval Brass Belt Chape”

Your email address will not be published.

0
    0
    Your Cart
    Your cart is emptyReturn to Shop